Kim, Kijoon.

Experiments have been performed which determined the fatigue crack growth rate (FCGR) of short cracks (a > 0.1mm) for five high strength steels (yield stress 370-570 MPa) in air and in natural seawater with and without cathodic protection. Attention was focused upon Regions I and Il of the classical FCGR-stress intensity range(Delta K) curve with particular consideration of the near-threshold behavior for short cracks. Single edge notch (SEN) three-point bend specimens and a direct current potential drop (DCPD) crack monitoring system were employed, and test parameters simulated offshore structure conditions. The results indicated enhanced FCGR for short cracks compared to macrocracks by 3-20 times in air and 2-6 in seawater free-corroding(FC). Also, the Delta Kth for short cracks was apparently lower than for long ones in both environments. The transition from short to long crack behavior occurred at constant $\Delta$K in each environment (15.6 MPa m in air and 10.0 MPa m in seawater(FC)) irrespective of initial Delta K (Delta K(0)). The transition crack length ranged from 0.25 to 1.6 mm and was inversely proportional to $\Delta$K(0). Scanning electron microscope fractography showed that the mechanism of enhanced crack growth rate was associated with secondary crack (SC) formation in air and SC or inter-granular cracking (or both) in seawater (FC). The enhanced FCGR for short cracks was minimized by polarization to -950 mV(SCE). Through an elastic-plastic fracture mechanics analysis using the J-integral parameter it was found that the influence of plastic deformation at the crack tip was approximately independent of crack length (short versus long), and the linear-elastic fracture mechanics analysis gave a realistic representation for fatigue behavior.